Boiler Not Working in Medford, MA
Your boiler has stopped working. Run the safe first checks — thermostat, power, pressure, and fuel supply — before you call. If you smell gas, leave the house and call (781) 701-0593 from outside.
Service overview
What to check first when your boiler stops working
Your boiler has stopped working. Before you call, run the checks on this page in order — thermostat, power, pressure, fuel supply, and the reset button. Most take a minute each, and they tell the technician exactly where the fault is. Everything here is safe to check from outside the boiler. If anything points to a gas smell or a leak, skip the checks and call (781) 701-0593.
! What each check tells you
Thermostat or power
The boiler does nothing at all — no lights, no sound. Usually the thermostat, the power switch, or a tripped breaker.
Pressure below 1 bar
The gauge reads near zero and the boiler locks out or will not fire. The system has lost water somewhere.
Burner lockout
The boiler tries to fire and stops, or the reset button does nothing. Points to ignition, fuel supply, or a sensor fault.
Scope of work
First checks, in order
Run these checks in order. Each one takes a minute, and each one rules something out. Stop at the first check that fails and call — or skip straight to the call if you smell gas or see water leaking.
-
01
Thermostat
Set to heat, above the room temperature, with fresh batteries if it takes them. A thermostat set to cool, off, or below the room temperature is the most common reason a boiler “does nothing”.
-
02
Power and breaker
Check the boiler’s power switch (usually a fused spur beside the boiler) and the breaker panel. If a breaker has tripped, reset it once. If it trips again, stop and call.
-
03
Pressure gauge
Read the gauge on the boiler. Roughly 1 to 1.5 bar when the system is cold is normal — the same range our repressurising guide uses. Near zero means the system has lost water — call before topping it up more than once.
-
04
Gas supply
For a gas boiler, check that the gas is on — other gas appliances, and the gas meter or shutoff. If you smell gas, leave the house and call from outside. Never touch gas lines.
-
05
Oil tank level
For an oil boiler, check the tank gauge. An empty or near-empty tank, or a tank that ran dry and was refilled, can leave air in the line and lock the burner out.
-
06
Reset button
Press the reset button once, and only once. If the boiler fires and stays on, watch it. If it locks out again, call — repeated resets mask the fault.
When to call instead of checking
An emergency call covers the fault, the fix, and a test before the technician leaves.
- ✓Same-day service for urgent calls, answered on the 24/7 emergency line.
- ✓Response within 2 hours — the figure we work to across Medford.
- ✓Upfront quotes — the confirmed price comes only on the call or at inspection time.
- ✓Licensed technicians on every visit, with a fully stocked service vehicle.
Local execution
Medford homes are mostly older — half were built before 1942 — and most heat with gas (about 62% of homes) or oil (about 14%). The first checks differ by fuel: a gas boiler needs its gas supply and ignition checked, an oil boiler needs its tank level and burner checked. The checks on this page cover both, in order, so you can tell the technician exactly what you found.
How Emergency Boiler Repair runs in medford
- • West Medford
- • East Medford
- • Medford Center
- • South Medford
If a check fails
Note which check failed and what you saw — the reading on the gauge, the thermostat setting, the breaker position. Tell the technician on the call so the visit starts with the right part.
Available 24/7 in medford
When emergencies happen, we answer
Our team is always ready to respond to boiler problems in medford. If the checks point to a fault, we typically arrive within 2 hours of your call, equipped with the tools and parts needed to address most issues on the spot. Our technicians are on-call 24/7, ensuring that you never have to wait long for assistance.
What not to do
Never open the boiler casing
The casing covers live parts and the combustion chamber. Leave it closed — diagnosis behind the casing is the technician’s job.
Never touch gas lines
Do not adjust, disconnect, or tighten any gas pipe or fitting. If you smell gas, leave the house and call from outside.
Never relight after a gas smell
A pilot light or burner must never be relit when gas can be smelled. Leave, call from outside, and wait for a technician.
Do not keep resetting a lockout
One reset is the limit. A boiler that locks out again has a fault that needs diagnosis — repeated resets make it worse.
Frequently asked questions
My boiler has no power at all — what do I check first?
Check the thermostat first — heat mode, set above the room temperature, fresh batteries if it has them — then the boiler's power switch and the breaker panel. If the breaker has tripped, reset it once. If it trips again, call (781) 701-0593 and do not keep resetting it.
What should the pressure gauge read?
Roughly 1 to 1.5 bar when the system is cold — the same range our repressurising guide uses. Below 1 bar, the boiler may lock out; near zero means the system has lost water. Call before topping it up more than once.
Can I press the reset button?
Yes — once. If the boiler fires and stays on, watch it. If it locks out again, or the reset button does nothing, call (781) 701-0593. Repeated resets can mask a fault and make the repair worse.
I smell gas — what do I do?
Leave the house immediately, do not switch anything on or off, and call (781) 701-0593 from outside. Do not relight anything and do not re-enter until a technician says it is safe.
Can I find boiler repair near me in Medford?
Yes — we work across every Medford neighborhood, from West Medford and Medford Hillside to Medford Square and South Medford, and most visits can be arranged without a long wait.
Related services
Emergency Boiler Repair
No heat or a boiler emergency — starting from $190.
Boiler Leak & Pressure Repair
Leaks, drips and pressure loss diagnosed and fixed before they cause damage.
Gas & Combi Boiler Repair
Specialist diagnosis and repair for gas and combination boilers.
Pilot Light & Ignition Repair
Pilot light and ignition faults diagnosed and repaired.
Boiler not working? Call now
Tell the technician which check failed and what you saw — the gauge reading, the thermostat setting, the breaker position. The confirmed price comes only on the call or at inspection time.